Operation
INSTRUCTION MANUAL AquaScat 2
11778E/1
43
7.9.
Setting the limits
So that the limits are not only displayed but also the outputs are switched, they have to be
configured accordingly.
Section 7.10
MANIPULATION
SUPPLEMENTARY INFORMATION
1.
Press the
Menu
button.
2.
Set the access code and confirm with
OK
.
Factory setting is
0
.
3.
Press the
Limits
button.
4.
Select limit 1 or 2.
5.
Select source.
Turb
Analog 1
Analog 2
6.
Define mode.
The following selection is available:
Off
(limit monitor of this chan-
nel is deactivated)
Exceeded
(limit active when
the set threshold value is ex-
ceeded)
Undershot.
(limit active when
the set threshold value is un-
dershot)
7.
Define upper limit, lower limit, cut-in delay
and cut-out delay with number pad.
Pressing the current number value
takes you to the entry mode.
8.
Press the
Meas
button.
Instrument again in normal operation.
