INSTALLATION INSTRUCTIONS
ELECTRICAL SHOCK HAZARD
READ, UNDERSTAND, and FOLLOW
these instructions
before installing
the equipment.
WARNING
SAFETY
Proper grounding is required to ensure personal safety.
Servicing this equipment should be performed by quali
fi
ed service personnel.
Save these instru
ctio
ns.
INSTALLATION
WIRING
Make sure that the mains voltage is appropriate and conforms with the
luminaire driver.
Connect
fixt
ure
GROUND
(green) wire to power supply
GROUND
(green) wire.
Connect
fixt
ure
WHITE
wire to power supply
(-) COMMON
wire.
Connect
fixt
ure
BLACK
wire to power supply
(+)LINE
wire.
Disconnect the Electrical supply power at the service panel (fuse or circuit breaker bo
x).
Failure to do so could result in serious
injury or death. Only quali
fi
ed electricians should install this
fixt
ure and the installa
tio
n MUST conform to the
Electrical Code Part I and all local codes and ordinances. Ensure that only proper tools, materials, and equipment are used to
complete the installa
tio
n.
1. Loosen phillips head screw(s) which secure heatsink to base. Remove heatsink from base hinge.
2. Choose correct mounting configuration from table (see Fig. 2).
Knock out corresponding mounting inserts from both mounting gasket and base.
pour la filerie correspondants à partir du joint d'étanchéité et de la base.
3. Pull junction box wires through round wiring gasket, then mount base securely using leveling bubble
for proper alignment. Apply silicone caulk all around mounted base to preclude water intrusion
.
4.
C
onnect fixture wiring per instructions below
.
5. Reassemble heatsink to base hinge and close fixture tightly. Secure phillips head screw(s) accordingly.