IMPORTANT SAFEGUARDS
When using electrical equipment, basic safety precautions should always be followed including
the following:
READ AND FOLLOW ALL SAFETY INSTRUCTIONS
a) This equipment is designed for use with UV radiation sources and must be installed in
compliance with competent technical directions to prevent risk of personal injury from UV radiation.
b) UV radiation can pose a risk of personal injury. Overexposure can result in damage to eyes and bare skin.
To reduce the risk of overexposure this equipment must be installed in accordance with the specifier or installers site
planning recommendations. This may include instructions on the relative location of each system
component, the minimum distances between UV-generating devices and other objects or surfaces, and
protection from line-of-sight exposure to UV radiation in occupied spaces located above and below the equipment
mounting area (e.g. upper floor balconies, open staircases, etc.)
c) UV and optical radiation can be reflected by surrounding surfaces such as ceilings, walls and duct work/pipes.
Since the reflective properties of surfaces can vary widely, it should be considered as part of site planning. Follow
the specifier or installers recommendations for selecting appropriate ceiling and wall finishes.
d) IT IS THE RESPONSIBILITY OF THE INSTALLER TO ENSURE THAT PERSONS WILL NOT BE EXPOSED TO EXCESSIVE
UV OR OPTICAL RADIATION DURING EQUIPMENT OPERATION. THIS WILL REQUIRE THE INSTALLER TO
CONDUCT AN ASSESSMENT OF IRRANDIANCE AND/OR ILLUMINANCE LEVELS IN THE SURROUNDING OCCUPIED
SPACES PRIOR TO OCCUPANCY.
e) Equipment should be mounted in locations and at heights where it will not readily be subjected to
tampering by unauthorized personnel.
f) Maintenance and servicing of this UV generating equipment shall be performed by authorized personnel.
Service personnel must wear appropriate Personal Protective Equipment (PPE) if the equipment will be in
operation during the maintenance or servicing work. Contact the equipment manufacturer for PPE
recommendations and guidance.
g) When replacing lamps, replace them only with the lamps for which the equipment is marked and intended.
h) The use of accessory equipment not recommended by the manufacturer may cause an unsafe condition.
i) Do not use this equipment for other than intended use.
SAVE THESE INSTRUCTIONS
Rev. 2 - 5/21
CAUTION: THE INSTALLATION AND SERVICING OF THIS PRODUCT MUST
BE PERFORMED BY A QUALIFIED ELECTRICIAN OR SERVICE PERSONNEL
Safety and Installation Instructions
UWL120-UNV-1/1-EB
90029520I84598322
ATTENTION : L’INSTALLATION ET L’ENTRETIEN DE CE PRODUIT DOIVENT ETRE
EFFECTUÉS PAR UN ÉLECTRICIEN OU UN MEMBRE DU PERSONNEL QUALIFIÉ.
CAUTION: Electrical luminaires are designed for permanent installation in ordinary (non-hazardous) locations in accordance with the National Electrical
Code and all applicable local codes. Do not use in areas of limited ventilation or in high ambient enclosures. The lamp and luminaire operate at high
temperatures, contact with combustible materials can cause fire and personal contact can cause severe burns.
© 2021 Signify Holding. All rights reserved. This document may be subject to change. No
representation or warranty as to the accuracy or completeness of the information
included herein is given and any liability for any action in reliance thereon is disclaimed.
All trademarks are owned by signify holding or their respective owners.
Signify Canada Ltd.
281 Hillmount Road
Markham, ON, Canada L6C 2S3
Telephone: 800-668-9008
Signify North America Corporation
200 Franklin Square Drive
Somerset, NJ 08873
Telephone: 855-486-2216