Chapter 12
| Link Aggregation Commands
– 375 –
channel-group
This command adds a port to a trunk. Use the
no
form to remove a port from a
trunk.
Syntax
channel-group
channel-id
no channel-group
channel-id
- Trunk index (Range: 1-24)
Default Setting
The current port will be added to this trunk.
Command Mode
Interface Configuration (Ethernet)
Command Usage
◆
When configuring static trunks, the switches must comply with the Cisco
EtherChannel standard.
◆
Use
no channel-group
to
remove a port group from a trunk.
◆
Use
to remove a trunk from the switch.
Example
The following example creates trunk 1 and then adds port 10:
Console(config)#interface port-channel 1
Console(config-if)#exit
Console(config)#interface ethernet 1/10
Console(config-if)#channel-group 1
Console(config-if)#
Dynamic Configuration Commands
lacp
This command enables 802.3ad Link Aggregation Control Protocol (LACP) for
the current interface. Use the
no
form to disable it.
Syntax
[
no
]
lacp
Default Setting
Disabled
Command Mode
Interface Configuration (Ethernet)
