Chapter 11
| Interface Commands
– 365 –
threshold-value
– The threshold of the transceiver voltage.
(Range: 0-655 in units of 0.01 Volt)
Default Setting
High Alarm: 3.50 Volts
HIgh Warning: 3.45 Volts
Low Warning: 3.15 Volts
Low Alarm: 3.10 Volts
Command Mode
Interface Configuration (SFP+ Ports)
Command Usage
◆
Refer to the Command Usage section under the
command for more information on configuring transceiver
thresholds.
◆
Trap messages enabled by the
command are sent to
any management station configured by the
command.
Example
The following example sets alarm thresholds for the transceiver voltage at port
1.
Console(config)interface ethernet 1/1
Console(config-if)#transceiver-threshold voltage low-alarm 4
Console(config-if)#transceiver-threshold voltage high-alarm 2
Console#
show interfaces
transceiver
This command displays identifying information for the specified transceiver,
including connector type and vendor-related parameters, as well as the
temperature, voltage, bias current, transmit power, and receive power.
Syntax
show interfaces transceiver
[
interface
]
interface
ethernet
unit
/
port
unit
- Unit identifier. (Range: Always 1)
port
- Port number. (Range: 25-26/49-52)
Default Setting
Shows all SFP interfaces.
Command Mode
Privileged Exec