Chapter 8
| Authentication Commands
802.1X Port Authentication
– 242 –
Example
Console(config)#interface eth 1/2
Console(config-if)#dot1x timeout re-authperiod 300
Console(config-if)#
dot1x timeout
supp-timeout
This command sets the time that an interface on the switch waits for a
response to an EAP request from a client before re-transmitting an EAP
packet. Use the
no
form to reset to the default value.
Syntax
dot1x timeout supp-timeout
seconds
no dot1x timeout supp-timeout
seconds -
The number of seconds. (Range: 1-65535)
Default
30 seconds
Command Mode
Interface Configuration
Command Usage
This command sets the timeout for EAP-request frames other than EAP-
request/identity frames. If dot1x authentication is enabled on a port, the switch
will initiate authentication when the port link state comes up. It will send an
EAP-request/identity frame to the client to request its identity, followed by one
or more requests for authentication information. It may also send other EAP-
request frames to the client during an active connection as required for
reauthentication.
Example
Console(config)#interface eth 1/2
Console(config-if)#dot1x timeout supp-timeout 300
Console(config-if)#
dot1x timeout
tx-period
This command sets the time that an interface on the switch waits during an
authentication session before re-transmitting an EAP packet. Use the
no
form
to reset to the default value.
Syntax
dot1x timeout tx-period
seconds
no dot1x timeout tx-period
seconds -
The number of seconds. (Range: 1-65535)
