Chapter 4
| System Management Commands
Line
– 118 –
Example
To specify 2 stop bits, enter this command:
Console(config-line-console)#stopbits 2
Console(config-line-console)#
timeout login
response
This command sets the interval that the system waits for a user to log into the
CLI. Use the
no
form to restore the default setting.
Syntax
timeout login response
[
seconds
]
no timeout login response
seconds
- Integer that specifies the timeout interval.
(Range: 10 - 300 seconds)
Default Setting
300 seconds
Command Mode
Line Configuration
Command Usage
◆
If a login attempt is not detected within the timeout interval, the connection
is terminated for the session.
◆
This command applies to both the local console and Telnet connections.
◆
The timeout for Telnet cannot be disabled.
◆
Using the command without specifying a timeout restores the default
setting.
Example
To set the timeout to two minutes, enter this command:
Console(config-line)#timeout login response 120
Console(config-line)#
disconnect
This command terminates an SSH, Telnet, or console connection.
Syntax
disconnect
session-id
