Chapter 4
| System Management Commands
Line
– 117 –
speed
This command sets the terminal line’s baud rate. This command sets both the
transmit (to terminal) and receive (from terminal) speeds. Use the
no
form to
restore the default setting.
Syntax
speed
bps
no speed
bps
- Baud rate in bits per second.
(Options: 9600, 19200, 38400, 57600, 115200 bps)
Default Setting
115200 bps
Command Mode
Line Configuration
Command Usage
Set the speed to match the baud rate of the device connected to the serial
port. Some baud rates available on devices connected to the port might not be
supported. The system indicates if the speed you selected is not supported.
Example
To specify 57600 bps, enter this command:
Console(config-line-console)#speed 57600
Console(config-line-console)#
stopbits
This command sets the number of the stop bits transmitted per byte. Use the
no
form to restore the default setting.
Syntax
stopbits
{
1
|
2
}
no
stopbits
1 - One stop bit
2 - Two stop bits
Default Setting
1 stop bit
Command Mode
Line Configuration
