Signal POWER STATION 4, Operating Manual

Page: 22 / 26

Series 4 Operating Manual - Nebula Issue 1.00
www.signal-group.com
P a g e | 22 of 26
Analogue Outputs
‒
Five 0-10Vdc analogue outputs are included as standard. These may be used for chart
recordings, to connect to an external datalogger, or to operate external alarms. Ten
analogue outputs are available with extended and special extended IO options. Up to ten
isolated 4-20mA outputs are also optionally available. (MI/995)
‒
These outputs are typically configured to provide measurements from each gas detector
channel (scaled to the range in use), and to indicate the range in use. For range indication,
1V = range 1 (lowest range), 2V = range 2, etc.
‒
The outputs may also be configured by users to provide outputs of internally measured
temperatures and pressures. This can be useful for fault finding as well as tracking sample
flows
MI/995
Ch number Pin Number Old Pin Colour New Pin Colour
1 1 Pink Brown
26 Black White
2 2 Pink Yellow
27 Brown Green
3 3 White Pink
28 Black Grey
4 4 White Red
29 Brown Blue
5 5 White Violet
30 Red Black
6 6 White Red/Blue
31 Orange Grey/Pink
7 7 White White/Pink
32 Yellow Brown/Green
8 8 White White/Green
33 Green Grey/Brown
9 9 White White/Yellow
34 Blue White/Grey
10 10 White Yellow/Brown
35 Purple Pink/Brown
Table 5 : Chart Output Pinout Colour