REMOTE ACCESS HOW TO
07.10.2021
Page 11
3.2.3
Using WIFI RAR as an Access Point (AP)
To setup an access point (AP) on the RAR using RAP:
1. Ensure the device electrical wiring is complete (Figure 3.3) and it has been
registered with the RAP. Refer to section 5.3 for registration.
2. On the RAP, select the device to be configured.
3. On the config page, edit the LAN settings.
4.
Click on the slide switch labelled “Enable Wi-Fi hotspot”.
5. Assign the SSID and password as required.
6.
Click “confirm” to store the settings.
7. Additionally, via the firewall settings it is possible to restrict or permit access to the
internet and/or the host network.
8. Push changes to the router to activate the new configuration.
Figure 3.9 Edit the LAN settings.
Summary of Contents for RAE 100
