ETT 731
BUILD-IN TERMINAL TOUCH
Page 16
05.12.2019
3. Lift rear panel of the terminal:
Sticker
4. Reconnect supply.
When exchanging the battery, caution must be taken to avoid a short circuit. Other-
wise, a defect can be caused in the terminal!
5. Using the strap, remove the battery from the holder.
6. Insert the new battery with the correct polarity (plus side facing the back of the terminal).
Lay the sticker lifted in step 5 back over the battery, disconnect the supply, place the back
panel of the terminal back on and tighten the locking screws.
7. Connect the ETT 731 supply.
