SIGMATEK DIAS-DRIVE 210-23, Manual, Page: 9 / 91

DIAS-DRIVE 210-23
30.03.2021 Page 9
1.5 European Guidelines and Standards
Servo amplifiers and components, which are designed for installation in electrical sys-
tems/machines for industrial use. With the installation into machines/systems, the servo
amplifier should not be operated until it has been determined that the machine/system
meets the requirements of the machine guideline 2006/42/EC and the EMV guideline
2014/30/EU.
Note: The machine manufacturer must perform a safety analysis for the
entire machine. With the appropriate measures, the manufacturer en-
sures that no injuries or damage can be caused by unexpected move-
ments.
− Conformity
With the supply of servo amplifiers within the European Union, compliance with the EMC
2014/30/EU and low voltage 2014/35/EU guidelines is mandatory.
With this servo amplifier, the harmonized standard EN 61800-5-1 (Electrical Power Amplifi-
er Systems with Adjustable Speed - part 5-1: Requirements for the Safety of Electrical,
Thermal and Energetic Demands) was used for the 2014/35/EU low voltage guideline.
With this servo amplifier, the harmonized standard EN 61800-3 (Electrical Power Amplifier
systems with Adjustable Speed - Part 3: EMC product standard including special test meth-
ods) was used for the 2014/30/EU guideline.
To meet the EMI conditions for the installation, the documentation contains detailed infor-
mation on:
•
shielding
•
grounding
•
wiring in the control cabinet
•
filters (if necessary)
The servo amplifier from the DIAS-Drive series was tested with the systems components
and the corresponding configuration described in this document.
Any change in the configuration and installation described in this document requires new
measurements to ensure that standards are met.