ACCESPOINT WLAN HGW
BWH 011
27.11.2020
Page 35
9
Assembly/Installation
9.1
Conditions
The following conditions must be met during assembly/installation:
•
Do not install the base station/ handheld operating panel in a damp environment.
•
The base station must be mounted near the equipment to control.
•
If several units are placed in the immediate vicinity, the base station must be mounted in
such a way that a clear optical assignment to the respective unit is visible.
•
When mounting the base station on uneven surfaces, ensure that the base station is not
subjected to torsion. Ensure that the base station is level.
It is also important to note that ...
•
the base station is connected with the function ground via the cable shielding.
•
the signal range should be configured so that the handheld operating panel functions
error-free throughout the entire operation area.
•
to mount the base station, the following applies:
o
Disks in compliance with 7089-4-200HV
o
Lock washer in compliance with DIN 7980, galvanized spring steel, size 4
o
Screws M4xXX-8.8 - XX indicates the length of the screw, this must be
selected according to the application and required screw-in depth
•
the antennae are not covered or damaged.
Do not expose the BWH to extreme environmental conditions such as heat,
humidity, strong magnetic fields, vibration or dust.
Ensure that the base station antennas are not shielded by metallic objects, as this can restrict
the functional range.
When mounting the base station, ensure that the requirements for the an-
tenna positions (dead spots), as well as operability are met.