EAN-SCD-Cameras
© SightLine Applications, Inc.
4
Figure 3: 4000-OEM / SLA-3000-CLK - SCD Mini Blackbird LC Camera Bench Setup
*
SLA-CAB-MIPI-02 FFC cable must be connected correctly. See
instructions before connecting the SLA-4000-MIPI board.
**
SLA-CAB-0305 can connect to SLA-CAB-0804 to facilitate a PC/USB connection to serial port 0 on the 4000-OEM. See the Serial
Communications section in the
5
Configuration Settings
This section covers the basic camera configuration settings in Panel Plus for the SightLine OEM video
processing boards.
Before connecting with the Panel Plus software, the OEM board should be powered up and connected
through:
-
a network switch or directly to the host PC (preferred) or,
-
Direct serial connection (for troubleshooting or if a network connection cannot be established).
See one of the corresponding OEM startup guides for connection and video streaming instructions:
•
•
IMPORTANT:
This procedure assumes that the customer has read the OEM startup guide(s) and
has a basic understanding of the following fundamentals:
•
Completed a functional connection between the SightLine video processing board and Panel
Plus application.
•
Familiar with Panel Plus controls.
•
Successfully streamed video in Panel Plus.
Network Switch or
PC Direct
SLA-CAB-1504 (J50)
Serial (SLA-CAB-504)
SLA-CAB-0403 (J4)
4000-OEM +
SLA-3000-CLK
Optional
SLA-4000-MIPI Board
RJ45 Ethernet
SLA-PWR-B12V-36W
**
USB to Serial SLA-CAB-0305 (optional)
SLA-CAB-0804 (J25)
(J6)
SLA-CAB-K010 (KEL)
*
SLA-CAB-MIPI-02 (J9)
SLA-SCD-100
(J8) USB-C
Direct
connect to
camera.
SCD Mini Blackbird
IMPORTANT:
Disconnect all input power to OEMs and adapter
boards before connecting or disconnecting cables.
Contact
surface facing
down when
inserting.
Camera PWR
