Sierra Profibus DP 600 Series, Instruction Manual, Page: 11 / 32

11
Address
ID
Dip Switch
1 2 3 4 1 2 3 4
1 1|0|0|0||0|0|0|0
14 0|1|1|1||0|0|0|0
60 0|0|1|1||1|1|0|0
125 1|0|1|1||1|1|1|0
Note: An address set with the dip switch has the highest priority and the slave address will use this
address when powering up!
Server Assigned Address
It is possible to change the address of the unit through the server. Perform the following steps to
change the address:
1. Assign a new address from the server
2. Set the dip switch to 128 (pin 8 on) or higher.
The assigned address will be used each time that the unit is powered.
Set Address (126)
It is possible to force the address of the unit to 126. Set the dip switch to zero and power cycle the unit.
The address is set to 126. The address can be changed by the server if needed. Do keep in mind that if
the dip switch remains set to zero, the address will be set to 126 at each power-up.