Administration
Rev 4 May.17
55
Figure 11-5: Backup/Restore Configuration Screen
In addition to backing up and restoring configuration settings, a common use case
for this feature is to save out a "master" configuration and then load that
configuration onto other oMG's. In this scenario be sure that any oMG specific
settings are configured on the unit after loading the configuration.
Note: Before restoring a configuration to an oMG, ensure that unit's version number
matches the version number of the unit on which the configuration file was created on. See
on page 52 for information on obtaining an oMG's version
information.
To backup the oMG’s configuration
1.
Navigate to General > Backup/restore.
2.
Click on Backup beside Backup configuration and save the file in an appro-
priate location.
To restore a configuration from a previous backup
1.
Navigate to General > Backup/restore.
2.
Click on Browse beside Restore configuration, select an oMG backup file and
click OK on the file dialog. The fully qualified filename will be shown in the
Restore configuration field.
3.
Click on Restore to complete the process. Once restoration is complete,
comprehensive details are provided under Restore Results.
Note: To cancel a configuration, click Cancel to remove the file details from the Restore
Configuration field and cancel the restore.
11.6 Configuring Services
Events generated on the oMG are reported to the AMM's DNS record set. The
configuration for this reporting can be accessed by navigating to
General > Services. These settings should only be modified under advisement of
Sierra Wireless Technical Support.