Sierra Wireless MP 700 Series, Command Reference Manual

Page: 36 / 118

MP 700 Series GPS AT Command Reference
34 2130309
!MPBARSVC=
<value>
!MPBARSVC?
Bar services
Controls the type of connections (GPRS or dial-up) that can be made by the
modem. (See
!MPFBSETUP for a discussion of dial-up connections and the
Fallback feature.)
The <value> parameter has these settings:
•
<value>=0
No services barred —GPRS connections are available;
where there is no GPRS service, the modem attempts a
Fallback dial-up connection. (The Fallback connection must
be set up using
!MPFBSETUP .) (This is the default.)
•
<value>=1
All services barred —No connections are available.
•
<value>=2
Fallback connections barred —GPRS connections are
available; the Fallback connection is never attempted.
•
<value>=3
GPRS connections barred —Any attempt to establish a
connection invokes the Fallback connection.
!MPBARSVC? returns the current setting.
!MPCFGDUMP?
<batch> Dumps configuration
Note: This command is only available on MP 750 GPS modems with firmware
version R2_2_3ap or later and on MP 775 GPS modems with firmware version
R3_0_9ap or later.
Returns settings for all parameters of the AT commands that are used to
configure the modem. The report lists each AT command followed by the setting
of each parameter of the command.
Parameter settings
To return all configuration settings, you must run the command twice, with
<batch> = 1 (to return the first batch of settings), then <batch> =2 (to return the
second batch of settings).
!MPCLIENTIP? Report the IP address
Returns the client IP address assigned to the modem by the network. If there is
no network connection, 0.0.0.0 is returned.
Table 3-9: Command Reference Table (ASCII Alphabetic)
Command Description