AirPrime MC Series Dev Kit Quick Start Guide
18
Proprietary and Confidential - Contents subject to change
2130705
Connect Antenna(s)
The mangOH Development Board includes three antenna ports—Main, Diversity,
and GNSS. Depending on the board version, the antenna connectors may be
U.FL or SMA connectors.
Note: The Diversity port is used only when the primary module (in J200) supports diversity.
The WP85 Series module included with the board does not support diversity.
Note: If the board has both SMA and U.FL connectors, it is configured by default to use
the SMA connectors.
To establish a mobile network connection, you must connect the main antenna,
and if desired, a diversity antenna.
To enable GNSS functionality, you must connect a GNSS antenna.
To connect an antenna to the Main, Diversity, or GNSS antenna connector:
1.
Place the mangOH Development Board face-up.
Figure 3-13: Possible Antenna Connector Types
2.
Attach the antenna:
·
If the board has only U.FL connectors, position the female connector (on
the antenna cable) on the male connector (on the board) and press firmly to
get a secure connection.
(Note that female connectors are rated for a limited number of reconnects
before the connector wears out, so should be left connected if possible.
SMA connectors
U.FL connectors
Diversity
GNSS
Main
Diversity
GNSS
Main