Rev 2 Jun.15
Proprietary and Confidential - Contents subject to change
11
3
3: Hardware Setup and Operation
This chapter describes how to install various components on the mangOH
Development Board, and how to configure and control features using connectors
and switches.
Insert/Remove Embedded Modules
The mangOH Development Board has two CF3 form factor module sockets for
use with Smart and Essential modules.
•
Primary (J200)—The primary module can be a ‘smart’ (WP series) or
‘essential’ (HL series) module.
•
Secondary (J600)—The secondary module, if used, must be an ‘essential’
module. for example, HL75xx.
To insert a CF3 form factor module:
1.
Place the mangOH Development Board Dev Kit face-up (as shown).
Figure 3-1: mangOH - Top View
Primary
(J200)
Secondary
(J600)
Mounting
holes
Mounting
holes
