Rev 3 9/21/17
20
41110479
5
5: Prepare Your mangOH Red For Development
In this chapter, you will update the CF3 module on your mangOH Red with the basic mangOH Red Platform
(application suite).
5.1 Build and Install Legato Platform and mangOH Red
Platform on Target
Now that your dev machine is set up with the Legato VM (which has Legato already pre-installed and configured),
you will:
•
Build the Legato Platform (development applications) on your dev machine.
•
Use the Legato Platform to build the mangOH Red Platform (target applications) and install it onto your target
(the CF3 module in your mangOH Red)
1.
Update the target’s firmware to the latest available version:
a.
Go to
https://source.sierrawireless.com
and do the following:
i.
In the Devices section, click AirPrime.
ii.
Click WP series.
iii.
Click your module type.
iv.
In the Software download section, click Firmware to display the list of available firmware packages.
v.
If you did not load the latest Drivers for your module yet, load them now—see
for instructions.
vi.
In the Combined Images table, click the Download link in the Windows EXE column for the Generic
carrier.
b.
Run the downloaded file and follow the instructions that appear.
c.
Wait (1–2 minutes) while the module reboots with the new firmware.
Important:
You MUST do the following step!
The Legato Application Framework and the mangOH Red
platform apps that you are going to install in this procedure both require you to have the correct (latest) firmware
installed on your CF3 module. The platform apps will not install if you do not have the correct firmware.
Note:
This will take several minutes to run.
n
IMEI