Modem Status, Customization, and Reset Commands
Rev.
6
Oct.18
Proprietary and Confidential - Contents subject to change
49
!CUSTOM
Note: Some customiza-
tions may not be
available for certain
chipsets, firmware
revisions, or devices.
Set/return customization settings
Set or return several customization values.
Password required:
Yes (Execution only) (see
for details)
Usage:
•
Execution:
AT!CUSTOM=<customization>, <value>
Response:
OK
Purpose:
Assign <value> to a specific <customization> setting.
•
Query:
AT!CUSTOM?
Response:
(list of enabled <customization>s)
OK
Purpose:
Display customizations that are currently enabled.
•
Query list:
AT!CUSTOM=?
Purpose:
Return a list of valid <customization> values.
Parameters:
<value> (Value being assigned to a specific <customization> setting)
•
Descriptions are included in each of the customizations described below.
•
Numeric value. Valid range depends on the <customization> type.
<customization> (String identifying customization setting. The default value for all
customizations is 0.)
Note: Use quotation marks around the customization string. For example,
AT!CUSTOM="CSDOFF",0.
•
"AUTONETWORKMODE"—(WP8548/WP75xx) Indicate if UE should revert to
Automatic Network mode after 60 seconds of Manual Network mode.
<value>:
•
0—Remain in Manual. (Default)
•
1—Revert to Automatic.
•
2—Remain in Manual if UE is attached to the network, otherwise switch to
Automatic.
•
“BANDSELEN“—Select GPIO28–31 usage type.
<value>:
•
0—General purpose GPIO
•
1—Antenna select (with
)
•
"BOOTQUIETDISABLE"—(WP8548/WP75xx) Enable/disable Linux kernel console
messages.
Disabling non-critical Linux kernel console logging improves the boot time.
<value>:
•
0—Disable Linux kernel console messages during boot (Default)
•
1—Enable all Linux kernel console messages during boot
(Continued on next page)
Table 3-2: Modem Status Command Details (Continued)
Command
Description
