Rev 002
37
WMP Development Kit User Guide
When the module receives an incoming call, this signal is low and then high for 0.5sec apiece, hence
the D101 LED blinks in the case of incoming calls.
13.4.
Switch “XMODEM” (SW100)
Warning:
The “XMODEM” switch must stay in the default “OFF” setting as shown in the figure below. Do
not use this switch.
Figure 18. XMODEM Switch Configuration (SW100)
Table 12:
XMODEM Configuration
Mode
XMODEM
Normal
OFF
-
-
13.5. Enabling the UART1 Function (SW101)
The UART1 interface can be enabled by moving the SW101 switch to “ON”..
Refer to Figure 19 for a visual representation.
Figure 19. XMODEM Switch Configuration (SW101)
SW100
SW101
