Installation and Startup
Rev 4 Nov.16
27
4119008
powering on in standby mode, ensure that it is supplied with more than 9 V
at startup. (You can change the low voltage standby mode settings once the
router is operational. If the Power LED is red, the router is in standby mode.
·
Ignition Sense (pin 3) is connected to the battery or power source (see
on page 14 for details)
LED Behavior
Table 2-10: LED Behavior
LED
Color / Pattern
Description
Power
Off
No power or input voltage
≥
36 VDC or
≤
7 VDC
Solid Green
Power is present.
Solid Red
Standby mode
If you want to operate the router using less than 9 V, change the Low
Voltage Standby settings (Refer to the ALEOS Software Configuration
User Guide, Services chapter)
Flashing Green
When you press the reset button for less than 5 seconds, flashing
green indicates when to release the reset button to reboot the router.
Flashing Red
When you press the reset button for 5–20 seconds, flashing red
indicates when to release the reset button to reset the router to the
factory default settings.
Flashing Amber
When you press the reset button for more than 20 seconds, flashing
amber indicates when to release the reset button to enter Recovery
mode. (See
Signal
Solid Green
Good signal (equivalent to 3–5 bars)
Solid Amber
Fair signal (equivalent to 2 bars)
Flashing Amber
Poor signal (equivalent to 1 bar)
If possible, Sierra Wireless recommends moving the router to a
location with a better signal.
Flashing Red
Inadequate (equivalent to 0 bars)
Sierra Wireless recommends moving the router to a location with a
better signal.
Note: The quality of the signal strength is measured using the appropriate parameters for the radio technology in use.
