Installation and Startup
Rev. 2 January 2021
35
41112510
Note: When you use ACEmanager to reset the router to the factory default settings, some settings
such the user password, network ID, network password, custom APNs, and low voltage standby are
preserved by default. However, you can configure the LX40 Reset Mode to reset all values,
including the user password. For more details, refer to the
ALEOS Software Configuration User
(Admin chapter).
–Or–
•
On the router, press the Reset button for between 5 and 20 seconds. (Release the
button when the Power LED flashes red.)
Once the LEDs resume their normal operating behavior, the reset is complete.
Note: When you use the Reset button to reset the router to the factory default settings, some
settings such the user password, network ID, network password, custom APNs, and low voltage
standby are preserved by default. However, you can configure the Reset button to reset all values,
including the user password. For more details, refer to the
ALEOS Software Configuration User
(Admin chapter).
Warning:
Before installation, please record the default password on the device label and store it
in a secure place.
Avertissement :
Avant déploiement de l'unité, veuillez enregistrer le mot de passe indique sur
l'étiquette et le garder dans un endroit sûr.
Recovery Mode
If the router fails to boot properly, it automatically enters recovery mode, or, if the router is
unresponsive to ACEmanager input and AT commands, you can manually put the router
into recovery mode.
Recovery mode enables you to update the ALEOS software and return the router to
working order. (For details, refer to the
ALEOS Software Configuration User Guide for
—Configuring your router chapter.)
To enter Recovery mode manually:
•
On the router, press the Reset button for more than 20 seconds. (Release the button
when the Power LED flashes amber.)
To recover the router:
•
Update ALEOS using the Recovery mode interface. Once the new ALEOS version is
successfully uploaded and installed, the router reboots and exits recovery mode.
When the process is complete, the ACEmanager login screen appears.
Note: After the recovery, you need to reload the radio module firmware store and templates.
To exit Recovery mode, if it has been inadvertently entered, do one of the following:
•
Press the reset button on the router to reboot it.
•
Click the Reboot button on the Recovery screen.
