10
face down on the board or turn it inside out.
Pleated Skirt:
Place pressing cushion under waistband and press. Rotate skirt until entire waistband is
pressed.
Slip the skirt over the board. Arrange the pleats. Press. Pleats may need to be pinned
to the ironing board cover. Do not use plastic head pins when using the press. Rotate
skirt until all pleats are pressed.
Jacket:
Sleeves without creases- Fold the sleeve on the seam line and place the seam line
fl
at
on the board. Allow the top edge of the sleeve to hang off the edge of the board. Press.
Lapels- Place lapels
fl
at, diagonally on the ironing board. Press. Use ironing cushion if
needed.
Ties and Ribbons:
Place the tie lengthwise on the board. Press. You can also
place them horizontally on the board and close the press
them pull tie or ribbon through it.
Embroidery items:
Place garment face down on ironing board to reduce wear and prevent damage.
If needed, place a towel over the garment then press. This will protect stitching,
rhinestones, etc.
CAUTION: When ironing embroidered, stitched items or garments with
rhinestones, sample an area to see if the steam or heat will affect the area
and proceed with caution.
STORING AND MAINTENANCE
CAUTION: Prior to storing or maintaining your steam press, isolate the unit
by removing the cord from the power socket and avoid immersing the unit in
water.
1)
Water may be left in water tank reservoir; however, it is recommended that if the
machine will be stored for a long period of time, any left over water in the unit
should be drained by pressing the steam burst button before the end of use until
the water tank is emptied.
2)
Wait approximately 30 minutes for press to cool down before storing. Once cooled,
lower the pressing plate onto the ironing board; pull down pressing handle completely,
then turn locking knob to “locked” position.
3)
Wipe steamer with soft cloth when/if necessary.
4)
Store in a cool, dry place.