Faults and what to do about them
en
31
Information on the display
panel
Display
Cause/Remedy
The door cannot be
locked, please open the
door again, then close it
and select
Start
/
Reload
Washing may be caught. Please open and close washing machine door again
and select
Start
/Reload
Ü
.
If required, shut washing machine door or remove washing and shut again.
If required, switch appliance off and on again; set programme and make individ-
ual settings; start programme.
Please open the tap
Turn on tap fully.
Supply hose kinked/jammed.
Water pressure too low. Clean the filter.
Please clean pump
Drain pump blocked. Clean the drain pump.
The water drainage pipe/drain hose is blocked. Clean the drainage hose on the
siphon.
Pause: Reload is not pos-
sible
Water level or temperature is too high.
Select
Start
/Reload
Ü
to continue the programme.
Door cannot be unlocked:
Water level or tempera-
ture is too high
Water level or temperature is too high.
Select
Start
/Reload
Ü
to continue the programme.
Auto power-off in ... sec-
onds
Appliance automatically switches off after ... seconds if it is not operated for
a prolonged period. In order to cancel the programme, press any button.
Water cooling
To protect the wastewater pipes, the hot detergent solution is cooled before
being drained.
Other displays
Turn the programme selector to
Off
. Appliance is switched off. Wait 5 s and
switch on again. If the display is indicated again, call customer service.