Cleaning and maintenance
en
29
1.
Switch off the appliance. Pull out the
mains plug.
2.
Open the service flap.
3.
Take the drainage hose out of the
holder.
4.
Remove cover flap, drain water into
a suitable receptacle. Press on
cover flap and insert drainage hose
into the holder.
Note:
Residual water may run out.
5.
Carefully unscrew the pump cover.
Clean the interior, pump cover
thread and pump housing (fan
impeller in the detergent-solution
pump must rotate).
6.
Reinsert and screw on pump cover.
Handle should be vertical.
7.
Close service flap.
Note:
To prevent unused detergent
from flowing into the outlet during the
next wash: Pour 1 litre of water into
dispenser
II
and start the
Spin
programme: (if only a drained cycle is
required: set rpm (spin speed) to
0
).
Drainage hose on the siphon
blocked
1.
Turn the programme selector to
Aus
(Off). Pull out the mains plug.
Note:
Residual water may run out!
2.
Loosen hose clip, carefully remove
drainage hose.
3.
Clean drainage hose and siphon
spigot.
4.
Re-attach drainage hose and secure
connection point with hose clip.
Filter in the water inlet hose
blocked
First, release water pressure in the
supply hose:
1.
Turn off the tap!
2.
Select any programme (except
Spin
programme).
3.
Select
Start
/Reload. Leave
programme for approx. 40 seconds.
4.
Switch off the appliance. Pull out the
mains plug.
5.
Clean the filter:
Disconnect the hose from the water
tap.
Clean filter with small brush.
and/or: