en
Installation and connection
44
Before washing/drying for the
first time
The washer dryer was inspected
thoroughly before leaving the factory. To
remove any residual test water, run the
Drum clean
programme the first time
without
washing.
Note:
The washer dryer must have
been installed and connected properly.
See chapter Installing
1.
Check the machine.
Note:
Never switch on a damaged
machine. Inform your customer
service.
2.
Insert mains plug.
3.
Turn the tap on.
4.
Switch on the appliance.
5.
Close the washing machine door.
Do not load any washing.
6.
Select
Drum clean
programme.
7.
Open the detergent drawer.
8.
Pour approx. 1 litre of water into
dispenser
II
.
9.
Add standard detergent to
dispenser
II
according
to manufacturer’s instructions for
light soiling.
Note:
To prevent frothing, use only
half the recommended amount
of detergent. Do not use any
standard or mild detergents.
10.
Close the detergent drawer.
11.
Select
Start
/Reload.
12.
When the programme ends, switch
off the appliance.
Your washer dryer is now ready for
use.
Transportation
Preparatory work
1.
Turn off the tap.
2.
Release the water pressure in the
supply hose.
Filter in the water inlet hose
blocked
3.
Drain any residual washing water.
Drain pump blocked
4.
Disconnect the washer dryer from
the power supply.
5.
Remove the hoses.
Installing transportation protection
devices:
1.
Remove covers and keep in a safe
place.
If required, use a screwdriver.
2.
Insert all 4 sleeves.
Clamp mains cable on the holders.
Insert and tighten the bolts.
