Operating the appliance
en
19
Reloading the laundry
When the programme has started,
washing can be topped up or taken out
as required.
Select Start/
Reload
. The washer dryer
checks whether a top-up is possible.
A:02 + PAUS are flashing
~
Top up
not possible.
Notes
■
If there is a high water level, high
temperature or if the drum is
rotating, the door remains locked
for reasons of safety and topping up
is not possible.
If the following is indicated on the
display panel:
To continue the programme, select
the
Start
/Reload button.
«
+ OPEN are lit
~
Top up
possible.
■
Do not open the door until
both
symbols
«
+ OPEN are lit.
■
Do not leave door open for
a prolonged period – water could
run out of the washing.
■
The top up function cannot be
activated during the drying phase.
Changing the programme
If you have started the wrong
programme by mistake, you can
change the programme as follows:
1.
Select Start/
Reload
.
2.
Select another programme. If
required, adjust the default settings
and/or select additional functions.
3.
Select
Start
/Reload. The new
programme starts from
the beginning.
Interrupting or ending the
programme
For programmes at high temperature:
1.
Select Start/
Reload
.
2.
Cool down laundry: select
Spin/
Rinse.
3.
Select
Start
/Reload.
For programmes at low temperature:
1.
Select Start/
Reload
.
2.
Select Spin/Rinse (if only a drained
cycle is required: set rpm (spin
speed) to - - -).
3.
Select
Start
/Reload.
For drying programme:
1.
Select Intensive Dry or Gentle Dry.
2.
Press button
Ù
(Drying)
, set 15 min
drying time.
3.
Select
Start
/Reload.
End of the programme
“Ÿš
or
$
(
Rinse hold
= without final
drain/spin cycle) is indicated in the
display field, buzzer sounds. Setting the
buzzer volume
If
$
(
Rinse hold
= without final drain/
spin cycle) was selected, press
Start
/
Reload button to start final drain/spin
cycle.
Notes
■
The programme continues by
pumping out the water and spinning
the washing (the standard spin
speed can be changed beforehand).
■
If only the water is to be pumped out,
press the Start/
Reload
button again
when the spin cycle starts. The
programme is interrupted and the
door lock is released. The washing
can be removed.
