Cleaning and maintenance
en
57
6.
Insert the air channel cover until you
feel it lock into place.
Caution!
Risk of material damage and
damage to the appliance
Operating with a missing or
defective air channel cover may lead
to material damage and damage to
the appliance if, for example, laundry
gets into the air channel.
Do not operate the appliance if the
air channel cover is missing or is
defective.
You have cleaned the appliance's air
channel.
Cleaning the base unit
When drying laundry, fluff and hair from
the laundry is collected in the fluff
collector. Your appliance's display
reports that the fluff collector is full.
Clean the appliance's base unit if the
following message appears in the
display:
Lint filter full. Length of drying
cycle affected. Remove and empty the
lint filter and the lint trap. Then clean
both with warm water.
.
You can also clean the appliance's
base unit if this message does not
appear in the display. e.g. before each
time maintenance work is carried out on
the appliance or the appliance is
switched off for longer than a month.
Notes
■
If the message
Lint filter full.
Length of drying cycle affected.
Remove and empty the lint filter
and the lint trap. Then clean both
with warm water.
appears in the
display, confirm the message in the
display.
■
Allow the appliance to cool down for
approximately 30 minutes after use
before commencing cleaning.
Clean the base unit as follows:
1.
To open the maintenance flap, take
hold of it at the top at both sides and
pull it down.
Summary of Contents for WT47X940EU
Page 75: ...6 ...