Faults and what to do about them
en
43
3
Faults and what to do about them
Faults and what to do about them
Faults
Cause/remedy
ð
on the display panel
and drying has been inter-
rupted.
■
Empty the condensation container and press the Start button.
■
Clean the filter in the condensation container
.
■
Run the intensive appliance care programme
.
■
Check that there is no debris blocking the air shaft or the supply line to the
pump.Open the maintenance flap to remove any debris
.
■
If the optional condensation drain has been installed, the drain hose may be
blocked or kinked.If the optional condensation drain has been installed, the
drain hose may be blocked or kinked. Check the hose for deposits and
flush the hose through. Lay the hose without any kinks.
ñ
on the display panel.
Clean the fluff filter
Dryer will not start.
■
Start button selected?
■
Mains plug plugged in or fuse/circuit breaker checked?
■
Programme selected?Select a programme.
■
Dryer door open? Close the door.
■
Is the childproof lock activated? Deactivate the childproof lock.
■
"Ready in" time selected? Programme starts after a delay.
Creasing.
■
Creasing occurs when you have exceeded the maximum load or selected
the wrong programme for the type of fabric. All the required information
can be found in the programme table.
■
Remove clothing from the dryer as soon as the drying programme has
ended. Creasing occurs when clothing is left in the drum.
Water is leaking out.
■
Not a fault; the dryer may be positioned on an incline. Level the dryer.
■
Check that there is no dirt or debris on the cover's seal. Clean the cover's
seal
Programme duration dis-
played changes during
drying.
Not a fault. The moisture sensors detect the remaining moisture in the load and
adjust the programme length accordingly (except timed programmes).
* Depending on the model
