Cleaning
en
29
D
Cleaning
Cleaning
Cleaning the dryer and the
control panel
:
Warning
Risk of death!
There is a risk of electric shock as the
dryer is operated with electricity.
Disconnect the dryer from the mains
before cleaning.
Clean the dryer using only water and a
soft, damp cloth.
Remove all detergent residue, spray
residue or other residues immediately.
Do not use cleaning agents or agents
for pre-treating laundry (e.g. prewash
sprays, stain removers). Do not use
high-pressure cleaners or steam jet
cleaners to clean your appliance.
Cleaning the moisture sensor
Note:
The dryer is equipped with a
stainless-steel moisture sensor. The
moisture sensor measures how damp
the laundry is.
After long periods of usage the moisture
sensor may become covered by a fine
layer of limescale or residues of
detergents and care products. Such
residues must be removed regularly as
the sensor function and in consequence
the drying result may be impaired.
Open the door and clean the moisture
sensor with a coarse sponge.
Caution!
Moisture sensor may be damaged.
Do not clean moisture sensors with
abrasives and steel wool.
Cleaning the EasyClean filter
When
ñ
appears in the display panel,
clean the EasyClean filter as follows:
1.
First clean the fluff filter
2.
Close the door of the dryer.
3.
Open the maintenance flap on the
heat exchanger.
4.
Release the levers on the EasyClean
filter.
5.
Use the grip handle to pull the
EasyClean filter out.
6.
Now take off the filter mat.
7.
Wash out the filter mat by hand
using clean water.
Notes
– If the filter mat is covered with
stubborn dirt, you can also
remove this carefully using a
vacuum cleaner.
– Do not use cleaning agents.
8.
Dry the filter mat by squeezing the
water out.
Note:
Only use the filter mat if it is
clean and dry.
Summary of Contents for WT43HVE8DN
Page 35: ...6 ...