Cleaning and maintenance
en
45
The drain hose at the siphon
is blocked
1.
Turn the programme selector to
Û
(Off)
. Pull out the mains plug.
2.
Loosen the hose clamp. Carefully
remove the drain hose; residual
water may leak out.
3.
Clean the drain hose and siphon
connecting piece.
4.
Re-attach the drain hose and secure
the connection point using the hose
clamp.
Filter in the water supply is
blocked
Release water pressure in the supply
hose:
1.
Turn off the water tap.
2.
Select the
Cotton
(activate
(
(varioSpeed)
setting)
programme.
Note:
If your appliance with
intelligent dosing system
*
, you also
need to deactivate the intelligent
dosing system.
3.
Select the
I
(Start/Reload)
button. Allow the programme to run
for approx. 40 seconds.
4.
Turn the programme selector to
Û
(Off)
.
5.
Pull out the mains plug.
Clean the filters:
1.
Disconnect the hose from the rear of
the appliance.
2.
Use pliers to remove the filter.
3.
Clean the filter with a small brush.
4.
Connect the hose and check for
leaks.
* Depending on the module
Summary of Contents for WN44A1E0DN
Page 55: ...6 ...
