Appliance settings
en
35
Q
Appliance settings
Appliance settings
You can change the following appliance
settings:
Settings that can be selected:
■
End signal
off – quiet – medium – loud – very
loud
Adjust the volume of the end signal.
■
Button signal
off – quiet – medium – loud – very
loud
Adjust the volume of the button
signals.
■
Auto power-off of the appliance
in 15 – 30 – 60 min – never
The appliance automatically
switches off after ... minutes (=
0 kWh energy consumption); to
switch on, press the
#
main switch
button.
■
Language
German
English
...
Change the displayed language.
■
Info: Drum cleaning
on – off
This instruction reminds you to carry
out a drum cleaning programme.
■
Dispenser content:
i-Dos
i
I
ô
content
Fabric softener - detergent
Select/change the dispenser
content.
■
Basic dosage:
i-Dos
i
I
ô
basis
10 ml – 200 ml
Set the basic dosage in accordance
with the recommendations of the
detergent/fabric softener
manufacturer.
■
Basic dosage:
i-Dos
ô
basis
10 ml – 200 ml
Set the basic dosage in accordance
with the recommendations of the
detergent manufacturer.
To change the settings, press and hold
both
basic settings 3 sec.
buttons for
approx. 3 seconds.
Notes
■
The settings are retained after the
appliance is switched off.
■
If you press and hold the buttons,
the settings run through
automatically.
H
Sensors
Sensors
Automatic load sensing
Depending on the type of fabric and
load, the automatic load sensing
function optimally adjusts the water
consumption and programme duration
in each programme.
Unbalanced load detection
system
The automatic unbalanced load
detection system detects imbalances
and ensures even distribution of the
laundry by repeatedly starting and
stopping drum spinning.
If the laundry is extremely unevenly
distributed, the speed is reduced or the
spin cycle is not performed for safety
reasons.
Note:
Place large and small items of
laundry evenly in the drum.
,
AquaSensor
depending on the model
During the rinse cycle, the AquaSensor
checks the degree of turbidity (turbidity
is caused by dirt and detergent residue)
of the rinsing water. The duration and
the number of rinse cycles depend on
the turbidity of the water.