Siemens WM16W790, Instruction Manual And Installation Instructions

Page: 41 / 56

Appliance settings
en
41
Programme end
- 0 - and
Ï
appear in the display panel.
The
Ü
button indicator lamp is off.
Removing laundry/switching
off the appliance
1.
Open the door and remove the
laundry.
2.
Press the
#
button. The appliance is
switched off.
3.
Turn off the tap.
Note:
Not required for Aqua-Stop
models.
Notes
■
Do not leave any items of laundry in
the drum. They may shrink in the
next wash or discolour another item.
■
Remove any foreign objects from the
drum and the rubber seal – risk of
rusting.
■
Wipe the rubber seal dry.
■
Leave the door and detergent
drawer open so that any residual
water can evaporate.
~
Page 43
■
Always wait until the programme
ends, as the appliance could still be
locked. Then switch the appliance
on and wait for it to unlock.
■
If the display panel goes off at the
end of a programme, the energy-
saving mode is active. Press any
button to activate the panel.
Q
Appliance settings
Appliance settings
You can change the following settings:
■
The volume of the buttons and the
information signals (e.g. at the end
of the programme)
■
Select/deselect the appliance's
automatic switch-off function
~
Page 13
■
Switch the drum-care information
signal on/off (depending on the
model). From
~
Page 29 onwards
You will need to activate the setting
mode in order to change these settings.
Activating the setting mode
1.
Press the
#
button.
The appliance is switched on and
the
Cottons
programme is shown at
position 1.
2.
Press the
Temperature
button and,
at the same time, turn the
programme selector clockwise to
position 2. Release the button.
The setting mode is activated and the
preset volume for the information
signals appears in the display panel.
You can now change the settings:
3RVLWLRQV