en
Positioning and connecting
22
Before washing for the first
time
The washing machine was thoroughly
tested before leaving the factory. To
remove any water that may be left over
from the test, run the first wash cycle
without
any laundry.
Notes
■
The washing machine
must be
correctly
installed
and
connected
.
(from
■
Never use a damaged machine.
Inform the after-sales service.
Preparatory work:
1.
Check the machine.
2.
Fill the dispenser
ß
and
i
.
3.
Remove the protective film from the
control panel.
4.
Plug into the mains.
5.
Turn on the tap.
Run the programme without laundry:
1.
Switch on the appliance.
2.
Close the door (do not load any
laundry).
3.
Set the
Drum Clean
90 °C
programme.
4.
Open the detergent drawer.
5.
Pour approx. 1 litre of water into
compartment
À
Á
.
6.
Pour standard washing powder into
compartment
À
Á
II.
Note:
To prevent foaming, only use
half of the amount of detergent
recommended by the detergent
manufacturer. Do not use detergents
that are intended for wool or
delicates.
7.
Close the detergent drawer.
8.
Press the
Ü
button.
9.
Switch off the appliance at the end of
the programme.
Your washing machine is now ready to
use.
www.devicemanuals.eu/
Summary of Contents for WM14YH89GB
Page 71: ...6 www devicemanuals eu ...
