en
Operating the appliance
38
Filling
:
Warning
Eye/skin irritation!
Detergents and care products may
spray out if the detergent drawer is
opened while the machine is in
operation.
Open the drawer carefully.
Rinse eyes/skin thoroughly if they come
into contact with detergents or care
products.
If accidentally swallowed, seek medical
advice.
Note:
Dilute viscous fabric softener and
fabric conditioner with a little water. This
prevents blockages in the washing
machine's piping.
Pour the detergent and care products
into the appropriate compartments:
1.
Pull out the detergent drawer as far
as possible.
2.
Add detergent and/or care products.
3.
Close the detergent drawer.
Measuring aid* for liquid detergent
*depending on the model
Position the measuring aid for dosing
the correct amount of liquid detergent:
1.
Pull out the detergent drawer. Press
down the insert and fully remove the
drawer.
2.
Slide the measuring aid forwards,
fold it down and click it into place.
3.
Reinsert the drawer.
Note:
Do not use the measuring aid for
gel detergents and washing powder, or
for programmes with prewash or when
the “Ready in” time is selected.
For models without a measuring aid
,
pour the liquid detergent into the
appropriate dispenser and place it in
the drum.
Change the programme
default settings
You can use or change the default
settings for this washing cycle.
To do this, repeatedly press the
corresponding button until the required
setting is displayed.
Note:
Pressing and holding the button
automatically runs through the set
values to the end. Then press the button
once more and you can then change
the setting values again.
The settings are activated without
needing to be confirmed.
The settings are not saved after
switching off the washing machine.
Default programme settings
Measuring aid
A
For liquid detergent
Compartment
II
Detergent for the
main wash, water
softener, bleach,
stain remover
Compartment
i
Fabric softener, liquid
starch;
do not exceed
max.
Compartment
I
Detergent for
prewash
