en
Operating the appliance
26
Child lock
(
w
3
δευτ
.)
You can lock the washing machine to
prevent the functions you have set from
being changed inadvertently. To do this,
activate the childproof lock.
To
activate/deactivate
, press and hold
the
Finish in
-
and
+
buttons at the
same time for approx. three seconds.
The
w
symbol is appears in the
display panel.
■
w
lights up: The childproof lock is
active.
■
w
flashes briefly: The childproof
lock is active and the programme
selector was turned or a button was
pressed.
Note:
The childproof lock remains
active, even once the washing machine
has been switched off. Before selecting
the next programme, deactivate the
childproof lock.
Adding laundry
After starting the programme, you can
add or remove laundry if necessary.
Press the
Ü
button to do this.
The
Ü
button indicator lamp flashes
and the machine checks whether it is
possible to add laundry.
If the following appears in the display
panel:
■
Both
the - P - and
Ï
symbols light
up, it is possible to add laundry.
■
- P - lights up, it is not possible to
add laundry.
To continue the programme, press the
Ü
button. The programme continues
automatically.
Notes
■
Do not leave the door open for too
long when adding laundry as water
from the laundry may leak out.
■
For safety reasons, the door remains
locked when the water level or
temperature is high, or while the
drum is turning, and it is not possible
to add laundry during this time.
■
The load display is not active during
reloading.
Changing the programme
If you have started the wrong
programme by mistake, you can
change the programme as follows:
1.
Press the
Ü
button.
2.
Select another programme.
3.
Press the
Ü
button. The new
programme starts from the
beginning.
Cancel the programme
For programmes at high temperatures:
1.
Press the
Ü
button.
2.
To cool down laundry: Select
Rinse
.
3.
Press the
Ü
button.
For programmes at low temperatures:
1.
Press the
Ü
button.
2.
Select
Spin
or
Empty
.
3.
Press the
Ü
button.
Programme end during rinse
hold
In the display panel,
$
flashes, and the
preset spin speed and remaining
programme length are displayed for the
selected programme.
Continue the programme by:
■
Pressing the
Ü
button or
■
Changing the spin speed, or setting
the programme selector to
Empty
and then pressing the
Ü
button.
