en
Sensors
36
Changing the brightness of
the touch display
Touch
à
again. The display for the
touch display's brightness
B
and the
preset brightness light up.
Change the adjustment value by
touching
N
or
M
:
Adjustment values:
Exit setting mode or:
Select/deselect the memory
function for drum care
Touch
à
again. The display for the
memory function for cleaning the drum
ä
lights up.
Touch
N
or
M
to select (on) or deselect
(off) the memory function.
Exiting setting mode
To exit and save the settings:
■
Wait for approx. 15 minutes or
■
Touch
à
one last time or
■
Switch off the appliance. The
selected settings will take effect the
next time the washing machine is
switched on.
H
Sensors
Sensors
Automatic load sensing
The automatic load sensing function
adapts the water consumption ideally to
each programme depending on the
type of fabric and the load.
Unbalanced load detection
system
The automatic unbalanced load
detection system detects imbalances
and ensures even distribution of the
laundry by repeatedly starting and
stopping drum spinning.
If the laundry is extremely unevenly
distributed, the speed is reduced or the
spin cycle is not performed for safety
reasons.
Note:
Place large and small items of
VoltMonitor
depending on the model
The colon in the Finish in-time display:
■
Flashes
, if the voltage is currently
too low.
■
Pulses
, if insufficient voltage was
detected during the programme.
Note:
Insufficient voltage may lead to
programme extensions and/or a non-
satisfactory spin result, for example.
1
Not very bright
2
Normal level of
brightness
3
Bright
4
Very bright
