Siemens WM14T790HK, Instruction Manual And Installation Instructions

Page: 29 / 46

Programme default settings
en
29
0
Programme default
settings
Programme default settings
The programme default settings are
displayed and can be changed in the
touch display after the programme is
selected.
You can find an overview of all possible
program settings on the supplementary
sheet for the installation and operating
instructions.
Temperature
Depending on what stage the
programme is in, you can change the
set temperature before and during the
programme.
The maximum temperature that can be
set depends on the programme that has
been selected.
Spin speed
Depending on what stage the programme
is in, you can change the spin speed (in
rpm; revolutions per minute) before and
during the programme.
Setting
2
: No spin; the water is only
drained. The laundry stays wet inside the
drum, e.g. for items that should not be
spun.
The maximum speed that can be set
depends on the model and the
programme that has been selected.
Ready in time
After selecting a programme, the
programme duration is displayed, e.g.
1:51
(in h:min (hours:minutes)).
Before the programme starts,
you can
move the time at which the programme
should be finished backwards, in
increments of 30 minutes and up to a
maximum of 24 h (h=hour).
After the programme starts,
the
selected time, e.g.
8.5 h
is displayed
and counted down until the washing
programme starts. The duration of the
programme is then displayed.
Note:
The programme duration is
automatically adjusted when the
programme is running. Changes to the
programme default settings or
programme settings, foam detection
function, unbalanced load detection, the
load or soiling may also change the
programme duration.
After the programme starts,
and while
the selected time is counting down, you
can change this as follows:
1.
Touch the control panel
‹
.
2.
Touch
N
or
M
to change the time.
3.
And touch
‹
again.
After starting the programme
, while the
programme is running, you can add or
remove laundry if necessary.
~
Page 34
Memory programme
â
You can save a selected programme with
your favourite settings here.
To store:
1.
Switch on the appliance.
2.
Select a programme.
3.
Change the settings and/or select
additional settings.
4.
Press and hold
â
on the control panel
for approx. three seconds.
The programme is saved if all of the
settings flash briefly.
To use the saved programme, touch
â
briefly after you switch on the appliance.
To change the saved programme, press
and hold
â
again for approx. three
seconds after selecting the new settings
.