Operating the appliance
en
33
being changed inadvertently in the
control panel.
To
activate
/deactivate the
childproof
lock
, touch and hold the control panel
w
3 sec for approx. three seconds.
The display switches to full brightness.
If you turn the programme selector or
touch the control panel while the
childproof lock is active, the
w
3 sec
indicator will flash briefly and a signal
will sound. The programme runs
through to the end unchanged.
Notes
■
To remove the laundry at the end of
the programme, deactivate the
childproof lock.
■
The childproof lock can be activated
no matter what status the appliance
is in.
■
The childproof lock remains active,
even once the washing machine has
been switched off.
■
If the appliance is switched off while
the programme is running and
childproof lock is activated, the
programme continues when the
appliance is switched back on.
Adding laundry
After starting the programme, you can
add or remove laundry if necessary.
To do this, touch the control panel
‹
.
The indicator flashes. The machine is
paused and checks whether it is
possible to add laundry.
If the display
®
goes out, it is possible
to add laundry. The door is then
unlocked and can be opened.
To continue the programme. touch
‹
again. The programme continues
automatically.
Notes
■
Do not leave the door open for too
long when adding laundry as water
from the laundry may leak out.
■
For safety reasons, the door remains
locked when the water level or
temperature is high, or while the
drum is turning, and it is not possible
to add laundry during this time.
Follow the information on the display
panel.
■
It is possible to add laundry during
the sensoFresh
î
programme.
■
The load display is not active during
reloading.
Changing the programme
If you have started the wrong
programme by mistake, you can
change the programme as follows:
1.
Touch the control panel
‹
.
2.
Select another programme.
3.
And touch
‹
again.The new
program starts from the beginning.
Note:
When cancelling programmes
that use active oxygen, the door will
remain locked for up to 25 minutes until
there is no longer any active oxygen in
the drum.
Switch the appliance on again if
necessary. The
®
and
î
symbols will
flash. If the symbols are off, the door
can be opened.
Cancel the programme
For programs at high temperature:
1.
Touch the control panel
‹
.
2.
To cool the laundry: Select
q
Rinse
.
3.
And touch
‹
again.
For programmes at low temperatures:
1.
Touch
‹
.
2.
Select
0
Spin
or
p
Empty
.
3.
And touch
‹
again.
Note:
When cancelling programmes
that use active oxygen, the door will
remain locked for up to 25 minutes until
there is no longer any active oxygen in
the drum.
Summary of Contents for WM14T780ME
Page 47: ...6 ...
