Siemens WM10K160GR, Instruction Manual And Installation Instructions

Page: 19 / 38

Operating the appliance
en
19
Adding laundry
After starting the programme, you can
add or remove laundry as required.
To do this, press the Start/
Pause
button.
The "Start/Pause" indicator lamp flashes
and the machine checks whether it is
possible to add laundry.
Note:
Do not leave the washing
machine door open for too long when
adding laundry as water from the
laundry may leak out.
If, in the display panel:
■
Both
the
YES
and
v
symbols light
up, it is possible to add laundry.
■
NO
flashes, wait until the
YES
and
v
symbols light up.
Do not open the washing machine
door until
both
the
YES
and
v
symbols are lit.
■
NO
lights up, it is not possible to add
laundry.
For safety reasons, the washing
machine door remains locked when
the water level or temperature is
high, or while the drum is rotating,
and it is not possible to add laundry.
To continue the programme, press
the
Start
/Pause button. The
programme continues automatically.
Changing the programme
If you have started the wrong
programme by mistake, you can
change the programme as follows:
1.
Press Start/
Pause
.
2.
Select the other programme.
3.
Press
Start
/Pause . The new
programme starts from the
beginning.
Cancel the programme
Programmes at high temperatures:
1.
Press Start/
Pause
.
2.
To cool the laundry: Select
Rinse
.
3.
Press
Start
/Pause .
For programmes at low temperatures:
1.
Press Start/
Pause
.
2.
Select
Spin
or
Empty
.
3.
Press
Start
/Pause.
Programme end during rinse
hold
– – –
0
appears on the display panel
and the Start/Pause button indicator
lamp flashes.
To end the programme, set the
programme selector to Spin/Empty or
select a spin speed. Then press the
Start
/Pause button.
Programme end
End
appears on the display panel and
the Start/Pause button indicator lamp is
off.
If the
x
symbol appears on the display
panel, the washing machine has
detected too much foam during the
wash programme and automatically
switched on a rinse cycle to remove the
foam.
Note:
Add less detergent for the next
washing cycle with the same load.
Removing laundry/switching
off the appliance
1.
Open the washing machine door
and remove the laundry.
2.
Set the programme selector to
Off
.
The appliance is switched off.
3.
Turn off the water tap.
Note:
Not required for Aqua-Stop
models.
Notes
■
Do not leave any items of laundry in
the drum. They may shrink in the
next wash or discolour another item.