Siemens WM10K160GR, Instruction Manual And Installation Instructions

Page: 15 / 38

Programme default settings
en
15
0
Programme default
settings
Programme default settings
The temperature, spin speed and
programme duration ("Ready in" time)
for all programmes are preset at the
factory.
These are displayed in the display panel
after selecting the programme.
You can change the default settings as
follows.
Spin speed
0
Depending on the programme
progress, you can change the spin
speed (in rpm; rotations per minute)
before and during the programme.
To do this, repeatedly select the
corresponding button until the required
setting is displayed.
Setting – – –
0
: Rinse hold = without
final spin, the laundry remains in the
water after the final rinse.
You can select "Rinse hold" to prevent
creasing if the laundry will not be taken
out of the washing machine immediately
after the programme has ended.
The maximum speed that can be set
depends on the model and programme
that have been selected.
Overview of programmes
~
Page 13
5
(Ready in) time
When you select the programme, the
relevant programme duration is
displayed.
The programme duration is
automatically adjusted when the
programme is running. Changes to the
programme default settings or
programme settings also change the
programme duration.
Before starting the programme, the
programme end ("Ready in" time) can
be preselected in increments of one
hour (h = hours) up to a maximum of 24
hours.
To do this, repeatedly press the
corresponding button until the required
setting is displayed.
Note:
The programme duration is
included in the selected "Ready in" time.
After the start, the preselected time e.g.
8 h
is displayed and the time counts
down to the start of the wash
programme. The programme duration is
then displayed, e.g.
2:30
(hours:minutes).
Changing the preselected time:
You can change the preselected time
after the start of the programme as
follows:
1.
Press Start/
Pause
.
2.
Press the
Ready in
5
button
repeatedly until the required number
of hours is displayed.
3.
Press the
Start
/Pause button.
Adding laundry while the pre-selected
time continues running:
1.
Press Start/
Pause
.
2.
The symbols
YES
and
v
light up in
the display panel. The washing
machine door can be opened and
you can add laundry.
3.
Close the washing machine door.
4.
Press the
Start
/Pause button. The
preselected time continues to run.