Document No
: 10102900
Page :
6 of 6
Document Title
: Procedure for Packing, Preserving, Handling and Shipping
of Jumpers/Harness with or without Sensors
Rev.
:
03
Restricted
Siemens Energy is a trademark licensed by Siemens AG
9 HANDLING
9.1
The Sensors are measuring instruments utilising very sensitive sensor elements.
CAUTION:
HANDLE THE JUMPER/HARNESS AND ANY SENSORS
WITH CARE THROUGH ALL ACTIVITIES, SUCH AS
TERMINATION, HYP TEST ETC., UNTIL READY FOR FINAL
ASSEMBLY.
Note:
All sensors shall have installed, a protective cover for the ring gasket surface/probe
and the electrical connector if applicable.
The sensors are also marked with a warning sign indicating that no mechanical
object should be placed into the probe tip.
9.2
DO NOT DROP.
9.3
DO NOT expose the equipment to vibration and shock.
9.4
DO NOT expose the equipment to high voltage sources.
9.5
DO NOT expose the equipment to environment conditions
beyond the storage specifications. ref. item 7 above,
or the operational environment specification, if operational.
9.6
To assist with the lifting of heavier jumpers/harness and sensors, a suitable rated
and certified soft fabric strop should be used in a double hitch (to prevent slippage)
attachment just behind the flange. Before any lifting is carried out it is recommended
that the probe and flange sealing areas are suitably protected.
10 SHIPPING AND MARKING
10.1 The jumper/harness and sensors shall be shipped in the Wooden crates and
packed as described in Ch. 5.
10.2 All markings shall be legible, permanent and un-obscured.
