Document No
: 10102900
Page :
5 of 6
Document Title
: Procedure for Packing, Preserving, Handling and Shipping
of Jumpers/Harness with or without Sensors
Rev.
:
03
Restricted
Siemens Energy is a trademark licensed by Siemens AG
6 UNPACKING
CAUTION:
THE JUMPER/HARNESS SHALL ONLY BE REMOVED
FROM ITS PACKAGING BY PERSONNEL
AUTHORISED BY THE CUSTOMER REFERRED TO
IN THE PACKING LIST AND CONSIGNMENT NOTE!
6.1.
Ensure that the crates are positioned flat on the floor with the correct
side uppermost.
6.2.
Open the hard case lid, remove the insulation/padding holding the sensors.
6.3.
Handle the jumper/harness and any sensors with care during operations.
7 STORAGE
7.1.
Equipment shall be stored in a covered and dry area, humidity control is not
required.
Storage temperature: -20 to +50°C.
7.2.
The equipment should be stored in the hard case used for transportation.
7.3.
The equipment is to be stored away from any vibration sources.
7.4.
The equipment is to be stored away from high voltage sources.
8 CRITERIA FOR PRESERVATION
8.1
The Crates shall be labelled as follows:
ELECTRONIC EQUIPMENT
HANDLE WITH CARE
MADE IN NORWAY
8.2
The equipment shall not be stored in vibrating areas.
8.3
Fork lift’s shall be used with care and only when strictly required.
8.4
All shock loads shall be avoided.
