Cleaning and servicing
en
49
Before the next wash
To prevent unused detergent from
flowing straight into the outlet in the
next wash, run the
Drain
programme
after you have emptied the drain
pump.
1.
Turn on the tap.
2.
Insert the mains plug.
3.
Switch on the appliance.
4.
Pour 1 litre of water into the
manual dosing compartment.
5.
Start the
Drain
programme.
Cleaning the water outlet
hose at the siphon
If the water outlet hose at the siphon
is dirty or the detergent solution is
not being pumped out, you must
clean these.
1.
Switch off the appliance.
2.
Disconnect the appliance's mains
plug from the power supply.
3.
Loosen the hose clamp and care-
fully remove the water outlet hose.
Residual water may leak out.
4.
Clean the water outlet hose and si-
phon connecting piece.
5.
Reattach the water outlet hose and
secure the connection point using
the hose clamp.
Clean the water inlet filters.
Clean the filter in the water inlet in
the event of blockages or if the water
pressure is too low.
Emptying the water inlet hose
1.
Turn off the tap.
2.
Set the
Cotton
programme.
3.
Start the programme and leave it
to run for approx. 70 seconds.
4.
Switch off the appliance.
5.
Disconnect the appliance's mains
plug from the power supply.
Summary of Contents for WAU28SS9DN
Page 67: ......
