1. Expose the area holding the SIM card hardware by unlatching the cover. The SIM card sits next to the
Ethernet connection (see Figure 11 SIM card installation).
2. Slide the micro SIM card into slot.
3. The SIM card socket is spring loaded. Slide the SIM card from the bottom upward into the slot until it stays in
place. To remove/replace the SIM card, press the SIM card upward and it will “spring” down and out of the slot.
3.5 Ethernet Connection – (Commercial and Smart Residential Units)
There is an Ethernet port standard on the VersiCharge controller module 10/100BASE-T port with an RJ45 modular connector.
The Ethernet port is capable of data rates up to 100 Mbps and supports ModBus/TCP protocol. The Ethernet can be used to
commission/configure chargers and monitor charger activity on a daily basis (download the VersiCharge Configurator Tool
(PC application) at usa.siemens.com/versicharge).
Figure 12. CAT6 Ethernet Port Connection
NOTE:
The Ethernet cable connector should NOT be attached to the Ethernet cable when it is pushed
through the rubberized Ethernet gland. This gland will not self-seal if the Ethernet connector is pushed
through the rubberized Ethernet gland and the NEMA 4 rating will be lost.
1. Push the Ethernet cable through the rubberized Ethernet gland.
2. Snake the Ethernet cable up through the back to the opening.
3. Connect the Ethernet RJ45 plug to the cable.
4. Insert the RJ45 plug from the bottom up into the Ethernet port.
23
VersiCharge™ AC Electric vehicle charging station
