1. Secure Charger to Mounting Bracket: Using the kit-supplied tamper-resistant screw– secure the charger cover with one screw
on the side.
2. Install Holster to Charger: Align Holster with guides in charger and drill pilot hole. Using the kit-supplied tamper-resistant screw,
use the third screw to secure the holster to the charger (hole at the top of the holster)
3. Standard installation (Figure 5) – Drill pilot holes and use the kit-supplied lag screw, #8 x 2-1/2” drywall screw, to secure the
holster to the wall stud.
4. Alternate installation (Figure 2, Section 2.3) – Drill pilot hole and use the fifth wallboard screw with anchor, screw into the wall.
2.6 Check the System
1. Turn the power on; the white Power Available light should illuminate. If it does not, verify that the outlet or wire is
putting out 240 or 208 V using the voltmeter.
2. With the Power Available light on, plug the Electric Vehicle Supply Equipment (EVSE) cable into the car. If you have any
fault lights, please see the LED Light Display table in Section 8.1.
Siemens VersiCharge Mobile App (Best used when only one charger is configured to one account): Download the VersiCharge
mobile app to your smartphone to get started using your charger. Find these applications at either Google Play (https://play.
google.com/store), or iOS stores (https://www.apple.com/ios/app-store/).
Siemens Configuration Tool (Best used when configuring multiple chargers per account): Download the VersiCharge
Configuration Tool (PC App) at usa.siemens.com/versicharge. Unzip the tool to a PC and install by following the screens. This tool
will allow charger management from a PC.
WARNING!
Do not force the connector into the receiver on the vehicle. If the connection
between the receiver and connector shows any resistance, inspect the pins in each and, if
damage is found, call a qualified service person.
16
VersiCharge™ AC Electric vehicle charging station
