2.3 Wallboard Mounting − Alternate (Use mounting holes on 4 corners)
Figure 2. Alternate installation of VersiCharge mounting
NOTE:
For installation, the mounting-bracket hinges will be pointing to the ceiling, and the flat side of
the bracket will be against the wall.
NOTE:
The VersiCharge can be mounted using 5 #12 x 1-½ LG Phillips head 0.375 head minimum with
5 #10 wall anchors
NOTE:
Recommended - The 5 anchors must be at least 61lb. anchors rated for 1/2” dry wall.
(SCREWS AND ANCHORS NOT INCLUDED IN KIT.)
1. Locate the mounting bracket not more than 12” above a 240 V outlet or if hardwiring, the wiring will come
through the bottom of the charger.
2. Level the mounting bracket and drill 4 holes, one in each corner of the bracket.
3. Place anchors into the wallboard until they are flush with the wall.
4. Place the mounting bracket over the holes (hinges facing upward, flat side of the bracket against the wall)
with the anchors and screw the mounting to the wall securely.
5. Add a fifth hole for mounting the holster once the unit is mounted on the wall. Place the holster on the wall
and mark the correct position for the hole. Refer to Section 2.5 and its graphic.
13
VersiCharge™ AC Electric vehicle charging station
