Siemens TXP-CLC, Manual

Page: 172 / 216

TXP CLC Course
Feed-back contact switchgear (RMS)
Name: RMS
Function: Defines whether the ”SAG” feed-back message of the blown fuse in the
switchgear can be detected, and with which type of switch. Additionally it is
determined here whether the TAG-OUT function (SP/BFLO) and operating
modes other than semiautomatic can be used.
Range of values: NO--Cont. / Tag--Out no
NC--Cont. / Tag--Out no
NO--Cont. / Tag--Out yes
NC--Cont. / Tag--Out yes
Basic setting: NO--Cont. / Tag--Out no
Meaning:
Feed-back contact & TAG-OUT active
⇒
RMS
Detection using NC contact No 0
Detection using NO contact No 1
Detection using NC contact Yes 2
Detection using NO contact Yes 3
Default setting: 1
Command output response in case of a fault (VBAF)
Name: VBAF
Function: Defines the response of the command outputs in the event of a fault. If
the parameter is activated the command outputs ALE and ALA will not be
deactivated when the following faults occur: Status discrepancy; Feedback error;
and / or Switchgear faulty. Can only be activated by enabling TAG-OUT via
parameter RMS.
Range of values: Not activated / activated
Basic setting:
Not activated.
MAN/AUTO changeover (MAUS)
Name: MAUS
Function: Defines whether the MAN/AUTO button in the operation window is
operable. Can only be activated by enabling TAG-OUT via parameter RMS.
Range of values: Not activated / activated
Basic setting:
activated.
TAG--OUT changeover (TOUS)
Name: TOUS
Function: Defines whether the TAG--OUT button in the operation window is
operable. Can only be activated by enabling TAG-OUT via parameter RMS.
Range of values: Not activated / activated
Basic setting:
activated.
Training Center
Copying of this document, and giving it to others and use or communication of the contents, are forbidden without express authority. Offenders are liable to the payment of
damages. All rights are reserved in the event of the grant of a patent or the registration of a utility model or design.
16